Machining and technology data
You must enter the machining technology data in the following input fields:
The machining technology data is as follows:
Parameter
Description
T
Tool number of the used tool (only for use of a manual tool-changer system)
F
Feedrate with choice of units mm/min (time feed) and mm/rev (revolutional feed),
S
Spindle type with the choice of units rpm (constant spindle speed) and m/min (constant cutting rate),
MR
Speed limitation for constant cutting rate
-X
Positions of the limit stops, the limit stops can be activated using the toggle field "ON/OFF"
-Z
+X
+Z
Note
Generally speaking, the relevant machining technology data must be entered before starting manual machining.
NOTICE
Device damage caused by excessive chucking device speed
When constant cutting rate (G96) is selected, the maximum permissible spindle speed, corresponding to the fitted tool
chucking device must be entered in the input field MR (spindle speed limitation).
Failure to pay sufficient attention to this point can lead to serious damage as a result of the chucking device speed being
exceeded.
4.2.1
Toggling the display
Functionality
In the position display screen, you can edit the displayed values using the vertical softkeys.
16
Programming and Operating Manual (Manual Machine Plus (MM+), Turning)
01/2017