Installing Rsts (Internal Option); Rdsu Installation; Rdsu Programming - Toshiba Strata DK14 Installation And Maintenance Manual

Installing RSTS (Internal Option)

Mate the RSTS connectors P2~P5 with the RDSU connectors P2~P5. RDSU connectors
P2~P5 are positioned to allow installation of the RSTS only in the proper position
7-19).

RDSU Installation

1. Ensure the SSTU subunit and optional subassemblies are securely attached to the RDSU
(Figure 7-19).
WARNING! The protective shield on the back of the RDSU is designed to protect the
2. Insert the RDSU into the appropriate slot, and apply firm, even pressure to ensure proper
mating of connectors. (See
CAUTION! To prevent system malfunction, DO NOT install the RDSU in slot 18 of the
DK40i system. See Chapter 2 – DK40i Configuration.
3. After installing the RDSU gently pull the RDSU outward. If the connectors are properly
mated, a light resistance is felt.

RDSU Programming

Enter Code 27 in Program 03 for a non-optioned RDSU, or enter Code 28 for an RDSU that
support off-hook call announce and data interface units. To program the RDSU standard
telephone ports (including the RSTS), see
the RDSU digital telephone ports, see
If there are no RDSU options, skip Program 03 can be skipped, and run Program 91 instead.
Table 7-13 RDSU, RSTS Controls, Indicators, and Connectors
Control/Indicator/Connector
RSTS connector P2/P3
RSTS connector P4/P5
R48S connector to P6
R48S connector to P7
Strata DK I&M 5/99
installer from potentially hazardous ring voltage. Do not remove this
shield.
Figure 8-22 on Page
"PDKU2 Programming"
Type of Component
10-pin connector
8-pin connector
6-pin connector
DK40i/DK424 Universal Slot PCBs
8-23.)
"RDSU Programming" on
on Page
Description
Connector for RSTS subassembly that provides
two standard telephone circuits.
Interface connector for R48S.
PEPU2 External Page Interface Unit
(Figure
Page 7-37. To program
7-6.
7-37