Mounting The Mpsa; Installing Togg L Er; Toggler Key - Toshiba Strata VI Installation Instructions Manual

SECTION 100-006-250
MPSA-200 INSTALLATION
DECEMBER 1982
lVl PSA and locate the template on that
location.
If
on a wall, use a spirit
level to verify that the drilling points
are level.
01.12
Place punch marks on the
mounting surface through the two rr+rr
marks on the template.
01.13
Drill through the mounting
surface with a 5/16-inch bit to prepare
the anchoring holes.
01.20 Mounting the MPSA
01.21 Press the anchor legs of the
togglers together, and insert them into
the anchoring holes (Figure 4) until
their neck flanges are flush with the
mounting surface. If insertion is diffi-
cult, tap them lightly with a hammer.
Wall Surface
~=I
FIGURE
ti
01.22 Tnsert a togglcr key in to the
small hole in the neck of each fas-
tener, as shown in Figure 5. This
should cause the anchor legs to rrpop"
open. Remove the toggler key.
..,.._Wall Surface
FIGURE 5
-Z-
01.23 Thread the screws into the
small holes in the center of the tog-
glers. Leave some clearance between
the bottom of each screw head and the
mounting surface (Figure 6).
Sheet Metal
Toggler
Flange
FIGURE 6
01.24 Place the MPSA against the
mounting surface with the screws
protruding through the holes (Figure 7).
FIGURE 7
01.25 Position the power supply so
that the narrower portions of the holes
slip over the screws, and (if the unit is ·
wall-mounted) the weight of the power
supply is supported. Tighten the screws.
01.26 If the power supply is tab-
le-mounted, make certain the unit rests
on its four rubber rrf eetrr and is secured
with the mounting bracket. This is es-
sential for proper cooling.