Toshiba Strata DK14 Installation And Maintenance Manual page 364

Station Apparatus
PC Attendant Console
To install the PC attendant console
See Figure 9-21 on Page 9-32
1. Connect the RATI to the PC COM port a with a standard RS-232 cable.
2. Use one-pair wiring to connect the MDF to an RJ11 jack at the attendant console location. If
you need to use a long cable, use two-pair for more power.
3. Plug in the handset cradle to the RJ45-jack.
4. Plug in the headset (if needed) to the handset base.
5. After programming the Strata DK424 system, install the PC attendant console software and
complete the Telephony Setup per the instructions on
Installation"
Figure 9-21 RATI Assembly/Disassembly
Notes
Do not cut HEADSET jumper unless you are connecting two headsets.
Cut CARBON jumpers if a carbon handset is connected to the RATHC handset cradle.
"REC OUT" can be used to monitor or record the attendant console talkpath. Both the attendant and
connected party will be monitored or recorded. The record level output from the attendant handset or
headset is approximately 3 dB below the connected party record level. Use a 1/8" mini audio jack.
"AUX IN" can be used to send audio to the attendant and connected party. The audio level to the
attendant is approximately 10 dB below the audio level sent to the connected party. Audio sent to the
outside party is limited to–15 dBv (CO Tip/Ring). Use a 1/8" mini audio jack.
See Figures 8-16
wiring information.
9-32
and follow these steps:
on Page 9-34.
Carbon Jumper
Headset Jumper
and 8-17 in Chapter 8 – DK40i/DK424 Universal Slot PCB Wiring
"PC Attendant Console Software
POW DTR DSR
RATI (Front View)
RATI PCB
DB9-FEMALE
(To PC COM Port Cable)
RJ11-JACK
(To RATU Modular Cord)
RJ45-JACK
(To RATHC Modular Cord)
REC OUT
(To Tape Recorder "RECORD" Input)
AUX IN
(Not Used)
Bottom Panel
for RATI cable
Strata DK I&M 5/99