Piou2, Pious2 Installation; Piou2, Pious2 Programming - Toshiba Strata DK14 Installation And Maintenance Manual

DK40i/DK424 Universal Slot PCBs
PEPU2 External Page Interface Unit
6. Mate IMDU2 connector J1 with PIOU2 or PIOUS2 connector P1 and IMDU2 J2 with P2 and
P3 (see
PIOU2 or PIOUS2 connectors P1, P2, and P3 are positioned to allow installation of the
Note
IMDU2 only in the proper position.
7. Refer to the Strata DK Programming Manual and turn LED 14 on in Program 77-1 to enable
IMDU2 operation.
Note The IMDU2 default station intercom or [DN] is #19.
8. Apply firm, even pressure to the IMDU2 to ensure proper mating of connectors.
9. Set the SW2 baud rate switch on the front panel to 300 or 1200, as appropriate, after the PCB
has been installed in the KSU/cabinet (in for 300 bps, out for 1200 bps).
Note Refer to Chapter 10 – Peripheral Installation for external option installation procedures.

PIOU2, PIOUS2 Installation

1. Make sure that P15 is in the Mu Law position for USA and Canada.
2. Ensure that the PIOU2 or PIOUS2 has been configured for the appropriate hardware options.
(Refer to Chapter 10 – Peripheral Installation for more details.)
3. Insert the PIOU2 or PIOUS2 (component side facing right) into the last slot ("S16") of the
Base KSU/cabinet if the system only has a Base KSU/cabinet and no Expansion KSUs/
cabinets. If there are Expansion KSUs/cabinets, install the PIOU2 or PIOUS2 in the highest
slot number in any KSU/cabinet. Apply firm, even pressure to ensure proper mating of
connectors.
Note In DK40i, PIOU2 or PIOUS2 can be installed in any available Expansion KSU.
4. After installing the PIOU2 or PIOUS2, gently pull the PCB outward. If the connectors are
properly mated, a slight resistance is felt.

PIOU2, PIOUS2 Programming

Program 03: Specify Code 41, 42, or 43 for the slot that will support a PIOU2 or PIOUS2. (See
"Multiple Serial Port Installation"
Note Program 76 assignments for RSIU, RSIS, RMDS will override Program 03 assignments
(41, 42, and 43) for SMDI, SMDR, TTY, and maintenance modem.
Program 10-2: Activates External Page with All Call Page (with access code #39 only, not with
&DOO 3DJH
Program 60: Assigns SMDR options.
Program 77-1: Assigns relay control and IMDU2 options.
Program 78: Sets Night Ringing over External Page
7-18
Figure 7-7).
on
button).
Page 11-2)
$OO
Strata DK I&M 5/99