Toshiba Strata DK14 Installation And Maintenance Manual page 367

3. In the Telephony Drivers dialog
box, if "ATT Telephone Telephony
SP" is shown in the driver list, go
to Telephony Setup below.
Otherwise, click the Add button to
display the Add Dialog screen.
4. From the Add Drivers dialog box,
if "ATT Telephone Telephony SP"
is in the list, then select it (it should
be highlighted) and press Add.
5. If "ATT Telephone Telephony SP" is not listed, press Add and type
c:\windows\system\att.tsp in the edit box. Click OK to return, select it in the list
and press Add.
Step 3: Set Up the Telephony Driver
1. From the Telephony Drivers dialog box, click the Setup button.
2. From the DK PC Attendant Configuration dialog box, set the COM port used for the RATI
interface (COM1, COM2, COM3, COM4).
3. Choose the processor type for the
connected DK424 system (RCTUB
or RCTUC/D).
4. Select the DK software version of
the system (R2, R3 or higher).
5. Enter emergency numbers as
programmed in Program 44-91~93
of the DK424.
6. Click the Default Configuration
button. This will set all the
parameters to match the default
values of the DK424.
It is extremely important
Important!
to match the parameters
set in the DK424 with
those in the Telephony
Setup or the PC attendant console will not know how to operate properly. Before
Step 7, go through each of the following telephony setup programs. ALL changes in
these following screens must match the corresponding values in the programming of
the DK424.
Strata DK I&M 5/99
Station Apparatus
PC Attendant Console
1023
1403
1024
9-35