Pc Attendant Console Software Installation - Toshiba Strata DK14 Installation And Maintenance Manual

Station Apparatus
PC Attendant Console
In Program *09 or 71, assign digits 3700 to port 024, and assign any other selected DID
extension number(s) to port 025–note that when the DID extension number assigned to either
console is dialed, calls will load share between consoles.

PC Attendant Console Software Installation

Step 1: Install the Software
The PC attendant console requires the installation of software on an IBM-compatible PC which
has been connected to the RATI. See
To install the software
1. Turn on the PC and open the Windows Program.
2. Insert Diskette #1 in drive A (or B).
3. Run A:\setup (or B:\setup) from Windows. The installation process will proceed and request
you to remove Diskette #1 and insert Diskette #2 as the program is decompressed and
installed.
A new program group will be added to your Windows Program Manager for the PC Attendant.
This will include three icons for running the PC Attendant, PCATT BACKUP, and TELEPHONY
SETUP (see screen below).
Step 2: Add the Driver
Before the PC attendant console can be used, the driver for the interface to the RATI must be
installed and Telephony Setup must be established. The following steps may be skipped if this
driver was previously installed.
1. Click the Telephony Setup
Icon or respond to the "Go
to Telephony Setup box"
at the end of the
installation process.
2. From the Telephony
dialog box, click the
Driver Setup... button.
9-34
"To install the PC attendant console" on Page 9-32.
1021
1022
Strata DK I&M 5/99