Toshiba Strata DK14 Installation And Maintenance Manual page 368

Station Apparatus
PC Attendant Console
7. The Default Configuration button will close the DK424 PC Attendant Configuration screen.
To make changes, select Setup again, then continue.
Default Key Assignments
From the DK PC Attendant Configuration screen, the Configure Keys button takes you to the DK
PC Attendant Key Configuration screen.The default key assignments are defined for R2 and R3.
These key assignments must match Program 59 of the DK. The Default Config button on this
screen sets the default keys only, whereas the Default Config button on the previous screen sets the
system database defaults.
To assign PC Attendant keys
1. From the PC Attendant
Configuration dialog box, select
the key that you want to change.
The Key Type drop-down box
shows a list of key names that can
be selected for that button. The
three-digit program codes are
shown in front of the button for
convenient programming. If the
programming telephone is next to
the PC attendant console, you can
look at the codes on the PC
Attendant screen while you
program.
2. Click OK after making your
selections.
Access Codes
Access Codes are used by the DK424 for dialing features. The access codes (dialing plan) must
match to allow the PC Attendant to dial the correct code to activate certain features. This is
normally left at default, but if Program 05 is modified, corresponding changes are needed here. If
no changes were made to Program 05, skip these steps.
To change access codes to match Program 05
1. From the DK424 PC Attendant
Configuration screen, click the
Access Code button.
2. In the Access Code dialog box,
click OK after making your
selections.
9-36
1026
1025
Strata DK I&M 5/99