Base Station - Toshiba Strata DK14 Installation And Maintenance Manual

Digital
Telephone
Top Assembly
RPCI-DI V.2s have stand offs that
require cutting when installed into a
DKT V.1~V.3. Use a wire cutter to trim
the top pieces of the stand offs at the
center of the telephone base before
mounting.
Do not cut the RPCI-DI stand offs when
installing on a DKT V.4 or higher.
Figure 9-5 RPCI-DI or PDIU-DI2 Installation into 2000-series Digital Telephone
Digital
Telephone
Top Assembly
To P2 of
Bottom PCB
Important!
Do not connect DIU cables
to HHEU connector.
Notes
• A 1000-series digital telephone cannot support an
HHEU and a PDIU-DI at the same time.
• 1000-series telephones do not support RCPI-DIs.
Figure 9-6 PDIU-DI Installation into 1000-series Digital Telephone
Strata DK I&M 5/99
DIU & VSU
To P2 of
Bottom PCB
Before
DVSU
HHEU
PDIU
PDIU/
DVSU
Red
Wire
Directory Tray
RS-232 (Female)
DB-25 Connector
DIU & ADM
To P1 of
Bottom PCB
Red
Wire
3751
After
Only RPCI-DI V.2s
have these stand offs
RS-232 (Female)
DB-25 Connector
To P1 of
Bottom PCB
Red
Wire
PDIU-DI PCB
PDIU-DI 1000 Digital
Telephone Base
Station Apparatus
Telephone Upgrades
Perception
Strap (only cut
if installed on
Perception)
RPCI-DI or
PDIU-DI2 2000 Digital
Telephone Base
Perception
Strap (only cut
if installed on Perception)
9-9