Rdtu Programming - Toshiba Strata DK14 Installation And Maintenance Manual

DK424 T1
RDTU T1 Interface Unit

RDTU Programming

The following programs select the number of channels supported by the RDTU and assign line
operation for the individual channels.
Notes
RDTU Tie lines can route per Program 04 [DN] assignment or Program 71 and 72 DNIS
assignments (see Program 17, LED 05).
RDTU DID lines can route per Program *09 assignments or Program 71 and 72 DNIS
assignments (see Program 17, LED 05).
Program 03: Specify Code 71 for an 8-channel RDTU, Code 72 for a 16-channel RDTU, or Code
73 for a 24-channel RDTU. (The 8-channel RDTU is the default.) Also, the Dual-Tone Multi-
Frequency receiver (RRCS) must be installed and assigned if RDTU Tie and/or DID lines are
DTMF.
If the T1 is 8 channels, skip Program 03 and run Programs 91, 91-1 or 91-9 instead.
Note
Program 04: Tie line digit translation (if T1 channel is Tie). Also see Programs 17 and 71~72.
Program *09: Use to translate DID digits to ring designated stations. Also see Programs 17 and
71~72.
Program 10-1: Use to enable or disable Two-Line Conference and Direct Inward System Access
(DISA).
Program 15: Use to assign DTMF/Dial Pulse dialing, DISA, and additional attributes to each line.
Automatic Release (AR) assignments only need to be made for loop start lines; AR is not needed
for ground start lines. Also use to enable DID lines with DNIS and ANI options.
Program *15: Use to make tenant assignments.
Program 16: Use to assign lines to line groups.
Program 17: Use to assign Tie/DID Auto Camp-on, and second dial tone.
Program *17: Use to assign intercept port for DID line calls to wrong or vacant numbers.
Program 30: If RDTU Tie and/or DID lines are Dial Pulse (DP—Program 15-1), then Program 30,
LED 11 should be ON for the Tie/DID station port numbers; if they are DTMF, LED 11 should be
OFF.
Program 39: Use to assign line access buttons to digital and electronic telephones.
Program 40: Use to assign station access to lines (incoming and outgoing).
Program 41: Use to assign station access to lines (outgoing only).
Program *41 Series: Run to assign RDTU channel line operation, and coding and framing modes.
Program 42-0, 1~8: Use to assign behind PBX/Centrex operation to each line.
Program *42 Series: Use to assign timing reference for RDTUs.
Programs 45~48: Use to define Toll Restriction for any line.
Programs *50, *51, *52: Use to define Caller ID/ANI assignments.
Programs 50~56: Use to define Least Cost Routing assignments.
Program 59: Use to assign T1 lines to attendant console buttons.
6-8
Strata DK I&M 5/99