Mounting The Base Ksu - Toshiba Strata DK14 Installation And Maintenance Manual

Strata dk series. digital business telephone solutions
Hide thumbs Also See for Strata DK14:
Table of Contents

Advertisement

DK40i Installation
KSU Mounting Considerations

Mounting the Base KSU

WARNING! To prevent electrical shock, make sure the power supply switch is turned OFF.
To mount the Base KSU
1. Place the Base KSU on the desired location on the mounting surface and mark the location of
the four screw holes (there is one on each corner). See
Make sure the location of the Base KSU meets the minimum clearance requirements specified
in
Figure 3-1 on Page
The Base KSU AC power cord is 4 feet 5 inches long.
Note
2. Drill holes on these marks.
If mounting the KSU directly to a wall, align screws with studs behind the wall. If using a hard
board between the KSU and the wall, install screws first to the hard board, and then secure the
hard board to the wall, making certain that screws are aligned with studs.
3. Secure screws approximately two thirds of the way into the top two holes on the mounting
surface.
4. Hang the unit from the top two screws and then secure the screws completely into the
mounting surface.
5. Finish securing the unit to the mounting surface by completely screwing the bottom two
screws into the wall.
6. Ground system according to
7. Connect applicable wiring (e.g., modular CO line cords, 25-pair amphenol connector cable–
see
Figure 3-25 on Page
wrap that comes with the Base KSU (see
connector clamp from plastic bag that comes with the Base KSU. Fasten the clamp to hold the
amphenol connector.
8. Connect Reserve batteries and plug battery cable into BATT connector of the KPSU16 power
supply (see
9. If the Expansion KSU is going to be installed, refer to
Page
10. Plug the AC power cable into an outlet and then turn ON the power supply switch.
11. Reinstall the front and side covers onto the Base KSU.
3-8
3-2.
"AC Power and Grounding Requirements" on Page
3-41) to the Base KSU and then fasten wiring to the unit with the tie
"Reserve Power Option" on Page
3-9. If not, proceed to
Step
Figure
Figure 3-8 on Page
3-17).
"Mounting the Expansion KSU" on
1.
3-6.
3-4.
3-13). Remove amphenol
Strata DK I&M
5/99

Advertisement

Table of Contents
loading

This manual is also suitable for:

Strata dk40iStrata dk424

Table of Contents