Table 9-2: Dialing Tab Parameters Description - AudioCodes MP-20 Series User Manual

User's Manual
Parameter
Dialing Parameters
Dialing Timeout
dial_timeout
Phone Number Size
phone_number_max_size
Enabled dialing complete
key
dial_complete_key/enabled
Complete dialing key
dial_complete_key/key
Dial Tone Timeout
offhook_tone_timeout
Reorder Tone Timeout
warning_tone_timeout
Unanswered call timeout
unanswered_call_timeout
Howler Tone Timeout
warning_tone_timeout
Flash min
flash_min
Flash max
flash_max
Enable Re-Answer
Timeout
offhook_tone_timeout
Send DTMF Out-Of- Band
out_of_band_dtmf
Version 4.4.3

Table 9-2: Dialing Tab Parameters Description

Defines the duration (in seconds) of allowed inactivity between dialed
digits. When you work with a proxy, the number you have dialed before
the dialing process has timed out is sent to the proxy as the user ID to be
called. This is useful for calling remote parties without creating a speed
dial entry (assuming the remote party is registered with the proxy).
Defines the maximum length of shortcut numbers that you can enter and
the maximum number of digits that you can dial.
When selected (default), you can define a key that when pressed forces
the device to make a call to the dialed digits even if there is no match in
the dial plan or digit map. The key is defined in the 'Complete dialing key'
field, which appears when this parameter is selected.
Note: This parameter appears only in 'Advanced' mode.
Defines the key that when pressed forces the device to make a call to the
dialed digits even if there is no match in the dial plan or digit map. The
default value is the pound (#) key.
Note: This parameter is available only if the 'Enabled dialing complete
key' is selected.
Defines the duration of the dial tone (in seconds). If the limit is exceeded,
the dial tone stops and you a reorder tone is played.
Defines the duration (in seconds) of the reorder tone. The reorder tone is
played, for example, when the device receives a SIP 486 response. If the
limit is exceeded, the reorder tone stops and a howler tone is played.
Note: This parameter appears only in 'Advanced' mode.
Defines the timeout before the device automatically sends a SIP
CANCEL message. When the device makes a call and the other side
doesn't answer, the device sends a CANCEL message after this timeout.
Note: This parameter appears only in 'Advanced' mode.
Defines the duration (in seconds) of the howler tone. If the limit is
exceeded, the howler tone stops playing. The howler tone informs a user
that the user's phone has been left in an off-hook state.
Note: This parameter appears only in 'Advanced' mode.
Defines the duration (in ms) after which you can begin to perform a flash
hook.
Defines the maximum duration (in ms) that the flash hook button can be
pressed, after which the call is disconnected.
When selected, the 'Re-Answer Timeout' field appears, allowing you to
define the timeout after on-hooking an active call and then off-hooking it
again. Once this time expires and the phone has not been off-hooked
again, the call is disconnected.
Defines how the DTMF tones are sent ('Inband', 'RFC2833', or 'Via SIP').
DTMFs are the tones generated by your telephone's keypad.
Note: This parameter appears only in 'Advanced' mode.
9. Configuring VoIP Parameters
Description
83 MP-20x Multimedia Home Gateway