Voice Menu Guidance; Configuring Voice Menu; Configuring Voice Menu Through The Web Interface; Configuring Voice Menu Through The Cli - AudioCodes MP-20 Series User Manual

9.6

Voice Menu Guidance

The FXS voice menu can be used to query a current firmware version and query or modify
basic network configuration parameters, using a standard touch-tone telephone connected
to one of the FXS ports.
9.6.1

Configuring Voice Menu

Voice Menu can be configured for through the Web interface or the CLI.
9.6.1.1

Configuring Voice Menu through the Web Interface


To configure Voice Menu through the Web Interface:
1. In the 'Voice over IP' screen click on 'Services' tab
2. Under 'Voice Menu' section Select 'Enabled' option to enable the Voice Menu feature.
3. Set Password – this allows to modify WAN Ethernet network settings using Voice
Menu (Admin level)
4. Click OK
9.6.1.2

Configuring Voice Menu through the CLI


To configure Voice Menu through the CLI:
1. Open a Telnet connection to the MP-20x device (Default: telnet 192.168.2.1)
2. Log in with administrator privileges (Default: admin/admin)
3. Run the following commands under the MP20x> prompt:
conf set /voip/services/voice_menu/enabled 1
conf set_obscure voip/services/voice_menu/password <password>
conf reconf 1
9.6.1.3

Voice Menu Configuration Parameters

The table below lists the configuration parameters that can be viewed and modified using
the voice menu:
Item Number at
Menu Prompt
1
2
3
4
User's Manual
Figure 1-1: Voice Menu Configuration
Table 1-1: Voice Menu Configuration Parameters
WAN IP address
Subnet Mask
Default Gateway IP address
Current firmware version
MP-20x Multimedia Home Gateway
Description
100 Document #: LTRT-50614