Configuring The Device Via Snmp; Status Monitoring Of System And Network Interfaces Via Snmp; Table 14-17: Table 3-13: Information Elements Available Via Mib-Ii - AudioCodes MP-20 Series User Manual

User's Manual

14.4.3.2 Configuring the Device via SNMP

The acMP20xConfig MIB section is structured in a similar hierarchy as the device's Web
GUI. Each parameter in the MIB has a matching parameter in the Web GUI and a matching
parameter in the gateway's configuration file. The MIB file defines the valid range and the
default value for each parameter. Typically, the customer integrates the MP20x MIB into
the customer's Network Management System (NMS) to automate the configuration
process.
Note: A special MIB object is defined to allow the device firmware upgrade triggered by
SNMP. The object acMP20xRemoteUpdate triggers a remote upgrade from the SNMP-
configured URL.

14.4.3.3 Status Monitoring of System and Network Interfaces via SNMP

SMNP can be used to monitor the status of the device. Status monitoring of the system
and network
(iso(1).org(3).dod(6).internet(1).mgmt(2).mib-2(1)). The following table shows some of the
information elements available via MIB-II:

Table 14-17: Table 3-13: Information Elements Available via MIB-II

Section
system
interfaces
ip
icmp, udp, tcp
ifMIB
Version 4.4.3
interfaces can

Description

Version Information

Up-time
Information per network interface:

Description

Type

Speed

MAC address

Traffic statistics

Errors
Assigned IP addresses and IP-related parameters
Transport-protocol specific statistical information
Information about network interfaces per RFC 2233
14. Remote Device Management
be done via
Available Information
229 MP-20x Multimedia Home Gateway
the standard MIB-II