Alcatel-Lucent 7450 ESS Series Configuration Manual page 431

ip-prefix-list — creates a list of IPv4 prefixes for match criteria in IPv4 ACL and CPM filter
ip-prefix-list-name — A string of up to 32 characters of printable ASCII characters. If special
mask — The subnet mask length expressed as a decimal integer.
netmask — Any mask epressed in dotted quad notation.
src-port
Syntax src-port {lt | gt | eq} src-port-number
src-port range start end
no src-port
Context config>filter>ip-filter>entry>match
Description
This command configures a source TCP or UDP port number or port range for an IP filter match
criterion. Note that an entry containing L4 match criteria will not match non-initial (2nd, 3rd, etc)
fragments of a fragmented packet since only the first fragment contains the L4 information.
The no form of the command removes the source port match criterion.
Default
no src-port
Parameters
lt | gt | eq — Specifies the operator to use relative to src-port-number for specifying the port number
src-port-number — The source port number to be used as a match criteria expressed as a decimal
range start end — Specifies an inclusive range of port numbers to be used as a match criteria. The
7450 ESS OS Router Configuration Guide
policies.
characters are used, the string must be enclosed within double quotes.
Values
1 — 32
Values
0.0.0.0 — 255.255.255.255
match criteria.
lt specifies all port numbers less than src-port-number match.
gt specifies all port numbers greater than src-port-number match.
eq specifies that src-port-number must be an exact match.
integer.
Values
0 — 65535
source port numbers start-port and end-port are expressed as decimal integers.
Values
0 — 65535
Filter Policies
Page 431