Table of Contents
Advertisement
Sample Output
B:CORE2# show router policy
===============================================================================
Route Policies
===============================================================================
Policy
-------------------------------------------------------------------------------
fromStatic
-------------------------------------------------------------------------------
Policies : 1
===============================================================================
B:CORE2#
policy-edits
Syntax
policy-edits
Context
show>router
Description
This command displays edited policy information.
route-table
Syntax
route-table [ip-prefix[/prefix-length] [longer | exact | protocol]] | [protocol protocol-name]
[all]]
route-table [family] summary
route-table tunnel-endpoints [ip-prefix[/prefix-length] [longer | exact | protocol]
route-table [ip-prefix[/prefix-length] next-hop-type tunneled
route-table [next-hop-type tunneled]
Context
show>router
Description
This command displays the active routes in the routing table.
If no command line arguments are specified, all routes are displayed, sorted by prefix.
Parameters
family — Specify the type of routing information to be distributed by this peer group.
ip-prefix[/prefix-length] — Displays routes only matching the specified ip-address and length.
longer — Displays routes matching the ip-prefix/mask and routes with longer masks.
exact — Displays the exact route matching the ip-prefix/mask masks.
Page 194
Values
ipv4 — Displays only those BGP peers that have the IPv4 family enabled and not
those capable of exchanging IP-VPN routes.
mcast-ipv4 — Displays the BGP peers that are IPv4 multicast capable.
Values
ipv4-prefix:
ipv4-prefix-length:
Description
a.b.c.d (host bits must be set to 0)
0 — 32
7450 ESS OS Router Configuration Guide
Advertisement
Table of Contents
