Table of Contents
Advertisement
local-address
Syntax
Context
Description
Parameters
local-name
Syntax
Context
Description
Default
Parameters
max-retries-estab
Syntax
Context
Description
Default
Parameters
Page 114
•
HPol intermediate destination arbiters where the intermediate destination is an L2TP tunnel.
local-address ip-address
no local-address
config>router>l2tp>group>tunnel
This command configures the local address.
ip-address — Specifies the IP address used during L2TP authentication.
local-name host-name
no local-name
config>router>l2tp>group
config>router>l2tp>group>tunnel
This command creates the local host name used by this system for the tunnels in this L2TP group
during the authentication phase of tunnel establishment. It can be used to distinguish tunnels.
The no form of the command removes thename from the configuration.
local-name
host-name — Specifies the host name, up to 64 characters in length, that the router will use to identify
itself during L2TP authentication.
Default
no local-name
max-retries-estab max-retries
no max-retries-estab
config>router>l2tp>group
config>router>l2tp>group>tunnel
This command configures the number of retries allowed for this L2TP tunnel while it is established,
before its control connection goes down.
The no form of the command removes the value from the configuration.
no max-retries-estab
max-retries — Specifies the maximum number of retries for an established tunnel.
7450 ESS OS Router Configuration Guide
Advertisement
Table of Contents
