Alcatel-Lucent 7450 ESS Series Configuration Manual page 215

*A:Dut-C# show router 1 tms routes
===============================================================================
TMS Routes (IPv4)
===============================================================================
Status
-------------------------------------------------------------------------------
Active
-------------------------------------------------------------------------------
No. of Routes: 1
===============================================================================
tunnel-table
Syntax tunnel-table [ip-address[/mask]] [protocol protocol | sdp sdp-id] [summary]
Context show>router
Description This command displays tunnel table information. Note that auto-bind GRE tunnels are not displayed in
show command output. GRE tunnels are not the same as SDP tunnels that use the GRE encapsulation
type. When the auto-bind command is used when configuring a VPRN service, it means the MP-BGP
NH resolution is refering to the core routing instance for IP reachability. For a VPRN service this object
specifies the lookup to be used by the routing instance if no SDP to the destination exists.
Parameters ip-address[/mask] — Displays the specified tunnel table's destination IP address and mask.
protocol protocol — Dislays LDP protocol information.
sdp sdp-id — Displays information pertaining to the specified SDP.
summary — Displays summary tunnel table information.
Output Tunnel Table Output — The following table describes tunnel table output fields.
Destination
Owner
Encap
Tunnel ID
Pref
Nexthop
Metric
7450 ESS OS Router Configuration Guide
Network
100.0.0.1/32
Label
The route's destination address and mask.
Specifies the tunnel owner.
Specifies the tunnel's encapsulation type.
Specifies the tunnel (SDP) identifier.
Specifies the route preference for routes learned from the configured
peer(s).
The next hop for the route's destination.
The route metric value for the route.
IP Router Configuration
Next Hop[Interface Name]
mda-2-1
Description
Page 215