Alcatel-Lucent 7450 ESS Series Configuration Manual page 126

Parameters
cflowd
Syntax
Context
Description
Default
Parameters
Page 126
transmit-interval — Sets the transmit interval, in milliseconds, for the BFD session.
Values
10 — 100000
Default 100
receive receive-interval — Sets the receive interval, in milliseconds, for the BFD session.
Values
10 — 100000
Default
100
multiplier multiplier — Set the multiplier for the BFD session.
Values
3— 20
Default
3
echo-receive echo-interval — Sets the minimum echo receive interval, in milliseconds, for the
session.
Values 100 — 100000
Default
100
cflowd {acl | interface} [direction]
no cflowd
config>router>interface
This command enables cflowd to collect traffic flow samples through a router for analysis.
cflowd is used for network planning and traffic engineering, capacity planning, security, application
and user profiling, performance monitoring, usage-based billing, and SLA measurement. When
cflowd is enabled at the interface level, all packets forwarded by the interface are subjected to
analysis according to the cflowd configuration.
If cflowd is enabled without either egress-only or both specified or with the ingress-only keyword
specified, then only ingress sampling will be enabled on the associated IP interface.
no cflowd
acl — Specifies the policy associated with a filter.
interface — Specifies the policy associated with an IP interface.
direction — Specifies the direction to collect traffic flow samples.
Values
ingress-only — Enables ingress sampling only on the associated interface.
egress-only — Enables egress sampling only on the associated interface.
both — Enables both ingress and egress cflowd sampling.
7450 ESS OS Router Configuration Guide