Alcatel-Lucent 7450 ESS Series Configuration Manual page 144

Router Interface Filter Commands
egress
Syntax
Context
Description
ingress
Syntax
Context
Description
flowspec
Syntax
Context
Description
Default
filter
Syntax
Context
Page 144
egress
config>router>interface
This command enables access to the context to configure egress network filter policies for the IP
interface. If an egress filter is not defined, no filtering is performed.
ingress
config>router>interface
This command enables access to the context to configure ingress network filter policies for the IP
interface. If an ingress filter is not defined, no filtering is performed.
flowspec
no flowspec
config>router>interface>ingress
This command enables flowspec filtering on an IP interface of the base router. Filtering is based on
all of the flowspec routes that have been received and accepted by the base router. Ingress traffic on
an IP interface can be filtered by both a user-defined ip filter and flowspec. In this case, the user-
defined ip filter entries are evaluated before the flowspec routes and the default action of the user-
defined ip filter applies as the very last rule.
The no form of the command removes flowspec filtering from an IP interface.
No interfaces have flowspec enabled.
filter ip ip-filter-id
filter ipv6 ipv6-filter-id
no filter [ip ip-filter-ip] [ipv6 ipv6-filter-id]
config>router>if>ingress
config>router>if>egress
7450 ESS OS Router Configuration Guide