Table of Contents
Advertisement
filter-sample
Syntax
Context
Description
Default
interface-disable-sample
Syntax
Context
Description
Page 420
sap sap-id — Specifies the physical port identifier portion of the SAP definition. Only Ethernet
SAPs are supported (including q-in-q, BCP, bridged Ethernet in Frame Relay or ATM).Only
Ethernet SAPs are supported (including q-in-q, BCP, and bridged Ethernet in Frame Relay).
Refer to
Common CLI Command Descriptions on page 567
parameter descriptions.
http-redirect url — Specifies the HTTP web address that will be sent to the user's browser. Note
that http-redirect is not supported on 7750 SR-1 or 7450 ESS-1 models.
The following displays information that can optionally be added as variables in the portal
URL (http-redirect url):
•
$IP – Customer's IP address
•
$MAC – Customer's MAC address
•
$URL – Original requested URL
•
$SAP – Customer's SAP
•
$SUB – Customer's subscriber identification string"
Values
255 characters maximum
[no] filter-sample
config>filter>ip-filter>entry
Specifies that traffic matching the associated IP filter entry is sampled if the IP interface is set to
cflowd acl.
If the cflowd is either not enabled or set to cflowd interface mode, this command is ignored.
The no form removes this command for the system configuration, disallowing the sampling of
packets if the ingress interface is in cflowd acl mode.
no filter-sample
[no] interface-disable-sample
config>filter>ip-filter>entry
Specifies that traffic matching the associated IP filter entry is not sampled if the IP interface is set to
cflowd interface mode. This allows the option to not sample specific types of traffic when interface
sampling is enabled.
If the cflowd is either not enabled or set to cflowd acl mode, this command is ignored.
The no form of this command enables sampling.
7450 ESS OS Router Configuration Guide
for SAP CLI command syntax and
Advertisement
Table of Contents
