Toptech MultiLoad II Manual page 44

Chapter 6 – Meter Commands
Per meter(6):
xxxx= meter status #0 in hexadecimal as:
union
{
unsigned int value;
struct
{
} flags:
} meter_status_0;
unsigned char program_clear_errors:1;
unsigned char remote_clear_errors:1;
unsigned char driver_clear_errors:1;
unsigned char clearing_errors:1;
unsigned char clear_totals:1;
unsigned char start_flow:1;
unsigned char stop_flow:1; ;
unsigned char high_flow:1;
unsigned char upstream_valve:1;
unsigned char downstream_valve:1;
unsigned char alarm_out:1;
unsigned char authorized:1;
unsigned char permissive:1;
unsigned char permissive_out:1;
unsigned char wm_clear_errors:1;
unsigned char unused0_15:1;
// command to clear errors
// command to clear errors
// command to clear errors
// currently clearing errors
// commanded to clear totals
// commanded to start flow
// commanded to stop flow
// forcing flow into high flow
// upstream valve status
// downstream valve status
// meter alarm output status
// meter authorized output status
// meter permissive input status
// meter permissive output status
// command to clear errors
// future use
44