Toptech MultiLoad II Manual page 42

Chapter 6 – Meter Commands
xxxx= preset status #1 in hexadecimal as:
union
{
unsigned int value;
struct
{
} flags:
} preset_status_1;
unsigned char program_clear_errors:1;
unsigned char remote_clear_errors:1;
unsigned char driver_clear_errors:1;
unsigned char clearing_errors:1;
unsigned char flow_batch:1;
unsigned char clear_batch:1;
unsigned char clear_load:1;
unsigned char flush_stage_needed:1;
unsigned char open_blk_val:1;
unsigned char blk_val_status:1;
unsigned char close_blk_val:1;
unsigned char remote_start:1;
unsigned char swing_arm:1;
unsigned char meter_stop:1;
unsigned char alarm_out:1;
unsigned char permissive:1;
// command to clear errors
// command to clear errors
// command to clear errors
// currently clearing errors
// command to flow/not flow product
// command to clear batch
// command to clear load
// product flush stage required
// block valve open
// block valve status
// block valve close
// remote start button status
// swing arm select status
// meter stop button status
// preset alarm output status
// preset permissive input status
42