Toptech MultiLoad II Manual page 43

Chapter 6 – Meter Commands
xxxx= preset status #2 in hexadecimal as:
union
{
unsigned int value;
struct
{
} flags:
} preset_status_2;
Modbus:
Supported through Modbus Extended Services Registers.
unsigned char permissive_out:1;
unsigned char load_interrupted:1;
unsigned char clearing_batch:1;
unsigned char alt_high_flow:1;
unsigned char gross_value_measured_for_trade:1; // gross value is W&M approved
unsigned char wm_clear_errors:1;
unsigned char batch_alarm:1;
unsigned char remote_clear:1;
unsigned char no_auto_batch_auth:1;
unsigned char open_diverter_val:1;
unsigned char diverter_invalid_bsw:1;
unsigned char unused2_11:1;
unsigned char unused2_12:1;
unsigned char unused2_13:1;
unsigned char unused2_14:1;
unsigned char unused2_15:1;
// preset permissive output status
// has loading been interrupted
// batch in process of clearing
// alt_high_flow input active
// command to clear errors
// one or more preset level alarms occurred
during the batch
// remote clear from FCM input
// prevents batch reauthorization
// divert valve open
// divert alarm
// future use
// future use
// future use
// future use
// future use
43