Toptech MultiLoad II Manual page 41

Chapter 6 – Meter Commands
Query 1 Responses:
xxxx= preset status #0 in hexadecimal as:
union
{
unsigned int value;
struct
{
} flags:
} preset_status_0;
unsigned char preset_enabled:1;
unsigned char preset_host_enabled:1;
unsigned char authorized:1;
unsigned char flow_active:1;
unsigned char batch_authorized:1;
unsigned char remote_msg:1;
unsigned char remote_desc:1;
unsigned char load_complete:1;
unsigned char end_batch:1;
unsigned char end_batch_done:1;
unsigned char tms_got_data:1;
unsigned char archived:1;
unsigned char batch_cleared:1;
unsigned char clearing_load:1;
unsigned char load_cleared:1;
unsigned char trans_done:1;
// preset is enabled
// preset enabled by host
// preset available for use
// flow state is not idle
// product & preset has been authorized
// remote message active
// remote descriptive message active
// no further loading on batch can be done
// MBE command processing started
// MBE command processing done
// MEB command received
// batch data has been archived into
transaction database
// batch has been cleared
// load clear has been issued
// load has been cleared
// transaction is done
41