Antenna Selection; Figure 4-13: Antenna Selection Page - Alvarion BreezeMAX PRO 5000 CPE Product Manual

Chapter 4 - Operation
Delete All Discrete Frequencies: to delete all discrete frequencies, click on

Delete All.
Discrete Scanning Frequencies: enables to enter discrete frequencies, as

follows:
»
»
Update Scanning Table: select this option to update the frequency scanning

table in run time (without resetting the unit).
Clear Best BS Table: select this option to clear the current Best BS Table.

Typically this should be done prior to initiating a full scanning process (see
below).
Force Full Scanning: select this option to initiate a full scanning process. The

BS table is cleared automatically.
4.8.3

Antenna Selection

The Antenna Selection page enables viewing the parameters of the integrated and
external antennas. The following parameters are displayed:
Radio Status

Antenna Gain: enables configuration of the external antenna gain (shown only

if the CPE is configured with an external antenna). Enter the gain value for the
external antenna and click Apply. The message "Antenna Param Set, done!" is
displayed. This operation requires a CPE reboot in order for the change to take
effect.
BreezeMAX PRO 5000 CPE
Update List of Discrete Frequencies: Enter a list of up to 10 discrete
frequencies in steps of 2.5MHz, separated by commas (no space). This list
will replace the current list of discrete frequencies.
Add One Discrete Frequency: Enter one frequency to be added to the
current list of discrete frequencies.

Figure 4-13: Antenna Selection Page

71
Radio Parameters
Product Manual