Alvarion BreezeMAX PRO 5000 CPE Product Manual page 97

Chapter 4 - Operation
Operation Mode: displays the convergence sublayer (CS) in the wireless access

network: IP CS (DSCP based classification) or Ethernet CS (VLAN based
classification).
Service Definition table: displays the Service Rules to be used for handling the

relevant classifiers (VLAN/DSCP) of packets processed by the units. For each
service rule, the following parameters are displayed:
»
»
»
»
»
»
»
BreezeMAX PRO 5000 CPE
Service ID: up to 8 non-overlapping Service Rules can be defined via the
BTS.
VLAN ID: from 0 to 4095
VLAN Priority: from 0 to 7
DSCP Start Value: from 0 to 63
DSCP Stop Value: from 0 to 63
DSCP Marking: Enabled/Disable:
Access VLAN: From 0 to 4095 or 4096 (Transparent). Transparent is used
to allow untagged packets.
When enabled, the DSCP value of a packet arriving from the Ethernet port
must be 0 (otherwise it will be discarded). Before forwarding to the wireless
port the 0 DSCP value will be replaced by the defined DSCP value and the
VLAN tag will be removed. For packets with this DSCP value arriving from
the wireless port, the defined VLAN tag will be added before forwarding it to
the Ethernet port (without changing the DSCP value).
If DSCP Marking is disabled, a packet with the defined VLAN tag (VLAN ID
and Priority) will be forwarded to the wireless port after removal of the
VLAN tag. The DSCP value of these packets is the DSCP configured (the
packet will be forwarded regardless of its DSCP value). For packets with the
configured DSCP value arriving from the wireless port, the defined VLAN
tag (VLAN ID and Priority) will be added before forwarding to the Ethernet
port.
80
Service Parameters
Product Manual