Guidelines For Positioning The Odu - Alvarion BreezeMAX PRO 5000 CPE Product Manual

Chapter 2 - Installation
2.1.1.2 Additional Installation Requirements
The following items are also required to install the ODU:
Double shielded Cat.5E outdoor ethernet cable with two RJ-45 connectors*

(90m) (see
and an RJ-45 connectors crimping tool.
For units that connect to external antenna: Antenna(s)* and RF cable* for

connecting the antenna to the ODU.
SAU* (SU Alignment Unit) for antenna alignment and status verification.

Grounding cable with an appropriate termination.

Installation tools and materials, including appropriate means (e.g. a 1" to 4"

pole) for installing the ODU (and antenna where applicable).
2.1.1.3 Optional Items
Tilt Pole Mounting kit*.

NOTE
Items marked with an asterisk (*) are available from Alvarion.
2.1.2

Guidelines for Positioning the ODU

This section provides key guidelines for selecting the optimal installation locations
for the ODU.
Select the optimal locations for the equipment using the following guidelines:
The ODU should be mounted on a 1"-4" pole. Its location should enable easy

access to the unit and its connectors for installation and testing.
The higher the placement of the ODU/antenna, the better the achievable link

quality.
The ODU/antenna should be installed to provide a direct, or near line of sight

with the BTS antenna(s). The ODU/antenna should be aligned to face the
general direction of the BTS.
BreezeMAX PRO 5000 CPE
Section 2.1.3 for details on approved cables and maximum length),
13
Installing the ODU of the CPE
Product Manual