Alvarion BreezeMAX PRO 5000 CPE Product Manual page 44

Chapter 2 - Installation
Connect the IDU-ODU cable to the RADIO/LAN+DC connector (See
2
and
CAUTION
Do not connect the data equipment to the RADIO/LAN+DC port. The RADIO/LAN+DC port supplies
DC power to the ODU, and this may harm other equipment connected to it.
Connect the power cord to the unit's AC socket, located on the rear panel.
3
Connect the other end of the power cord to the AC mains after verifying that
the unit is rated for the voltage in the country of use; the AC range is indicated
on the back side of the CPE-IDU-1D.
NOTE
The color codes of the power cable are as follows:
Brown
Blue
Yellow/Green
To comply with safety regulations, the shield of the ODU-IDU outdoor-rated
4
Ethernet cable must be connected to protective ground (earth). The grounding
point can be either inside the building, or immediately at the entry point to the
building, depending on where a protective ground is available. See
the ODU-IDU Cable" on page
CAUTION
Grounding the ODU-IDU Ethernet cable must be performed by a professional installer in
conformance with local safety regulations.
Verify that the POWER LED located on the front panel is lit, indicating that the
5
unit is supplying power to the radio port.
Configure the basic parameters and align the antenna as described in the
6
applicable sections of
Connect the 10/100 Base-T ETHERNET connector(s) to the data equipment.
7
The cable connection should be a crossed Ethernet if connecting to a
hub/switch and a straight cable if connecting directly to a PC Network
Interface Card (NIC).
NOTE
The length of the Ethernet cable connecting CPE-IDU-1D to the user's equipment, together with the
length of the IDU-ODU cable, should not exceed 100 meters.
BreezeMAX PRO 5000 CPE
Figure 2-10).
Phase ~
Neutral 0
Ground
Chapter
Installing the IDU-1D Indoor Unit of the CPE
28.
3.
27
Figure 2-8
"Grounding
Product Manual