One-Shot Recording - Panasonic VariCam LT Operating Manual

One-shot recording

Recording takes place once for the set amount of time.
1
Set [MENU] → [REC SETTINGS] → [REC FUNCTION] → [REC MODE] to [ONE SHOT].
f When [VFR] is set, one-shot recording is not available.
2
Set the following related items from [MENU] → [REC SETTINGS] → [REC FUNCTION].
f [REC TIME]: Duration of each recording
f [START DELAY]: Delay time from the time when the <REC> button is pressed until the time the first recording starts
3
Press the <REC> button.
f Recording is performed for the time set in step
f To stop recording, perform one of the following operations.
- Press and hold the <REC> button for at least two seconds. After recording operation is performed once, recording stops.
- Press and hold the <HOME> button for at least two seconds.
f To clear settings, set [MENU] → [REC SETTINGS] → [REC FUNCTION] → [REC MODE] to [NORMAL].
f As an indicator of the viewfinder screen, the control panel, or the output from the <SDI OUT 1>/<SDI OUT 2> terminals, the following is displayed
at the top left of the screen.
- Displaying the control panel
During recording: [i REC] lights up in red
During pause: [i REC] is inverted in red and white
During stop: [i REC] in black character
- Displaying the viewfinder screen and the output from the <SDI OUT 1>/<SDI OUT 2> terminals.
During recording: [i-REC]
During pause: [i-PAUSE]
During stop: [INTERVAL]
@ NOTE
t The card access LED will flash in orange while operating in the one-shot recording mode. Do not remove the P2 card. The data is destroyed when it is
removed, so repair the clip. Note that even when the clips are restored, the last three to four seconds of the recording may still be lost (maximum ten
seconds in cases that the card was removed during recording that divides clips).
t Pre-recording does not function.
t Audio is not recorded.
t Recorded data (data recorded until the recording was stopped) is included in one file.
t When one-shot recording is continuously performed, the recording operation may be slower.
t One-shot recording is not possible when [MAIN CODEC] is set to [AVC-LongG50] or [AVC-LongG25].
Chapter 4 Video Recording and Color Grading — Special recording functions
2
, and then pauses.
– 86 –