Panasonic VariCam LT Operating Manual page 158

Item
[FILTER]
[EXTENDER]
[Y GET]
[TC]
[P2 CARD REMAIN]
[BATTERY REMAIN]
[GPS]
[REC TALLY]
[CLIP NAME]
[USER CLIP NAME
(TYPE3)]
[AUDIO LEVEL METER]
[REMOTE CTRL]
[VF SDI MARKER] [VF SDI SW]
[PB MARKER SW]
[MARKER & CHAR LVL]
[CENTER MARKER]
[SAFETY MARKER]
[SAFETY AREA]
[FRAME MARK]
Chapter 10 Menu Operations — Menu list
Displays/hides the optical filter transmittance.
[ON], [OFF]
f Factory setting: [ON]
Displays/hides the extender.
[ON], [OFF]
f Factory setting: [ON]
Displays/hides brightness of Y GET.
[ON], [OFF]
f Factory setting: [ON]
Displays/hides the time code, user bits, and duration counter displays.
[TCG/TCR], [TCG], [OFF]
f Factory setting: [TCG/TCR]
Displays/hides the display of the remaining recording free space of a P2 card.
[ON], [OFF]
f Factory setting: [ON]
Displays/hides the remaining battery charge level.
[ON], [OFF]
f Factory setting: [ON]
Displays/hides GPS signal reception status.
[ON], [OFF]
f Factory setting: [ON]
Displays/hides the method of displaying the recording status.
[RED]: The red tally lamp lights up.
[GREEN]: The green tally lamp lights up.
[CHAR]: The characters [REC] are displayed in the viewfinder.
Regardless of this setting, when [SDI REC REMOTE] is set to [ON], or [SDI RAW] is set to anything other
than [OFF], the red tally lamp will illuminate during recording with an external device.
f Factory setting: [RED]
Displays/hides clip names.
[ON], [OFF]
f Factory setting: [OFF]
Switches display/hide of the user clip name when [MENU] → [REC SETTINGS] → [REC META DATA] →
[USER CLIP NAME] is set to [TYPE3].
[ON], [OFF]
f Factory setting: [OFF]
Switches display/hide of the audio level meter.
[ON], [OFF]
f Factory setting: [OFF]
Switches display/hide of ROP app control status.
[ON], [OFF]
f Factory setting: [ON]
Switches display/hide of the marker display against the output from the <VF SDI> terminal and the control
panel screen.
[ON], [OFF]
f Factory setting: [ON]
Switches display/hide of the marker display against the playback video output from the <VF SDI> terminal
and the control panel screen.
[ON], [OFF]
f Factory setting: [OFF]
Sets the marker and character luminance.
[50%], [60%], [70%]
f Factory setting: [50%]
Switches the center marker.
[1]: + (large)
[2]: Open center (large)
[3]: + (medium)
[4]: Open center (medium)
[5]: + (small)
[6]: Open center (small)
[7]: + (very small)
[OFF]: Does not display.
f Factory setting: [1]
Selects the type of frame for the safety zone marker.
[1]: Box
[2]: Corners
[OFF]: Does not display.
f Factory setting: [OFF]
Sets the size of the safety zone marker.
[80%] - [100%] (1% step, constant aspect ratio)
f Factory setting: [90%]
Switches enable/disable of the frame marker.
[ON], [OFF]
f Factory setting: [OFF]
– 158 –
Description of settings