Fujitsu ARROWS NX F-01K Instruction Manual page 73

g Switch to video
Tap to display a selection screen for switching to video call
on the other party's terminal. If it is accepted, switching to
video call is available.
･
To switch to voice call during a video call, tap
[Switch to voice call].
h Display submenu
During a voice call : You can add a call for another speaker
using Voice clear ON/OFF, call on hold
and call waiting.
During a video call : You can operate switch to voice call,
switch of speech output, or switch of image area of yours
and third party's.
* To activate the call on hold function, the call waiting
service is required.
i Image of the other party
･
Tap the screen to switch the other party's image between
in full-screen and normal screen.
･
If the camera function of the other party's terminal turns
off, the stationary image immediately before turning off
is displayed.
j Your image
k Switch camera for sending image
Switch camera (in-camera/out-camera) to shoot image for
sending.
✔INFORMATION
･
→
･
･
*
/canceling on hold,
･
･
･
71
Enable Voice clear to improve call sound to be heard clearly
by emphasizing the other party's voice or adjusting the
listening sound.
For subscribers of Call waiting, during a voice call, tap
[Add call] to make a second call.
When speaker phone is ON, you can talk handsfree using the
speaker.
During a video call, to switch voice output when connecting
a Bluetooth device, →[Switch audio output destination]→
Select the voice output device.
During a video call, when a calling screen is not displayed
because you change to another screen, your image will not
be sent to the other party.
Voice clear does not support video calls.
→
Phone