Fingerprint Settings - Fujitsu ARROWS NX F-01K Instruction Manual

3
[NEXT]→Follow the onscreen instructions to
register your iris→[DONE]
･
To add another fingerprint, tap [Add fingerprint] and
then follow the onscreen instruction to register
fingerprint. Up to 5 fingerprints can be saved.
❖
Operating fingerprint authentication
1
On the lock screen, touch the fingerprint sensor
(P) with registered finger.
･
If the authentication failed, perform the authentication
operations with the security unlock preference used in
combination (pattern/security code/password)
registered at fingerprint registration.
❖

Fingerprint settings

1
From the Home screen,
[Security]→[Fingerprint settings]→
Authenticate
2
Set each item
(Fingerprint name) : The registered fingerprint name is
displayed. Tap to rename or delete fingerprint data.
Add fingerprint : Add a fingerprint registration.
→[Settings]→
153
◆ Iris authentication function
The terminal is equipped with the iris authentication with
which authenticate the security with registered iris
information.
❖
Precautions when using a camera for iris
authentication and LED
･
Do not place your eyes closer than 20 cm from the terminal
while the iris authentication LED is lit.
･
The camera for iris authentication is waterproof, however
malfunction may occur if water or dirt adheres to the surface
of the camera for iris authentication. When the iris
registration or authentication fails often, wipe any water or
dirt surface with a dry, soft and static-free cloth. The
phenomenon may be improved.
･
The following conditions may cause failure or damage:
- Strike or give a hard shock
- Scratch or pick with a pointed object
- Rub hard with a fingernail or hard object such as metal
piece of strap and scratch the surface of the camera for iris
authentication
- Scratch or stain the surface of the camera for iris
authentication or LED with soil etc.
- Cover with a sticker or paint with ink etc.
･
The following conditions may make iris authentication
scanning difficult or reduce the authentication performance
and the function may not be available. Clean occasionally
the camera for iris authentication, LED, and peripheral of the
proximity sensor (the front upper side of the terminal).
- Dirt of dust, sebum, etc. attachment or condensation of
moisture of sweat etc.
Settings