Fujitsu ARROWS NX F-01K Instruction Manual page 33

u
v
Left side
*5
u Slot cap
v Strap hole
w P Power key/Exlider/Fingerprint sensor→P37, P39, P53,
P151
Power on/off and set/cancel sleep mode.
x Volume key
Adjust sound volume, or set/cancel Manner mode by
pressing and holding the volume down key for 1 second or
more.
w
x
Right side
*1 A sticker bearing the CE mark, FCC ID, IMEI information, etc. is
attached. Please do not peel off the sticker or remove the
nameplate.
*2
Putting a protective sheet or sticker on the sensor or covering the
sensor with fingers may cause erroneous operation or incorrect
sensing result.
*3 Do not put stickers or a film on mouthpiece/microphone area. Also
do not cover it with a finger. May cause erroneous operation or
incorrect sensing result.
*4 It is built-in the terminal. Covering around the antenna by the hand
may affect the quality.
*5
Install/remove after turning off the power. To avoid water or dust
infiltration, be sure to close firmly.
■ Notes
･
The back cover cannot be removed. Trying to remove it with
excessive force may cause damage or malfunction.
･
The battery is built into the terminal. You cannot replace it
by yourself.
31
Before using the terminal