Fujitsu ARROWS NX F-01K Instruction Manual page 36

･
Data transfered from the other device to a microSD card may
not be displayed or played on the terminal. Data transfered
from the terminal to a microSD card may not be displayed or
played on other devices.
✔INFORMATION
･
A microSDXC card can be used only SDXC devices. Inserting
a microSDXC card into a device that does not support SDXC
may damage or destroy the data saved on the microSDXC
card. Do not insert one. If you want to reuse a microSDXC
card on which data is destroyed, format the microSDXC card
(all data will be erased) on an SDXC device.
･
When copying data to/from a non-SDXC-compatible device,
use a microSDHC card or microSD card complying with
standards of device to share data.
･
When using an application handling large amount of data
such as video recording, use a high-speed microSD card
(Class 10 or more is recommended).
･
For speed class of microSD card, up to Class 10 can be
available.
･
The terminal supports up to UHS Class 3 speed microSD
card.
◆ Installing/Removing microSD card
･
Install/remove after turning off the power.
･
Be sure to use the slot cap when inserting a microSD card.
Installing of a microSD card alone may cause a malfunction.
■ Installing
a Face the display side of the terminal up, put your fingertip
into the groove and then open the slot cap→P26
b Draw the slot cap in the direction of the arrow straight and
horizontally→P32
c With the metal side facing down, set the microSD card into
the slot cap.
･
Be sure to fit the microSD card into the slot cap so as not
to shift.
d Check that the display side of the terminal faces up and
then insert the slot cap in the direction of the arrow
straight and horizontally→P33
e Firmly press the slot cap to close→P26
34
Before using the terminal