Fujitsu ARROWS NX F-01K Instruction Manual page 132

4
Set each item
･
Tap [Select mode] to select the communication mode
for Multi-connection.
･
When a Wi-Fi network is registered in [Frequently used
hotspot], the terminal preferentially use the Wi-Fi when
you are connected to the registered Wi-Fi network.
❖
About applications compatible with
Multi-connection
The applications displayed by tapping [Select application] are
the Multi-connection targets.
✔INFORMATION
･
When the running application is selected in [Select
application], enabling the setting may take time.
To enable the setting immediately, end the running
application and restart the terminal.
･
Some functions may be restricted when using Wi-Fi for the
site that distinguishes network connection (dメニュー
(dmenu)→Items in "My docomo (お客様サポート)" (My
docomo (customer support)) etc.). In that case, turn Wi-Fi to
Off before use.
･
Multi-connection cannot be used in the following cases.
- In Airplane mode
- During international roaming
- Tethering in use
- Connected to VPN
- VPN in connection
･
If the Wi-Fi network registered in [Frequently used hotspot]
behaves erratically, some applications that usually restrict
communications to Wi-Fi may temporarily switch over to
packet communications (LTE/3G).
･
When Multi-connection is set to OFF, high-speed download
also turns OFF.
･
If data amount exceeds the limit of subscribed budget plan
and transmission speed is limited, Multi-connection does not
work.
◆ Wi-Fi Auto ON/OFF
Turn Wi-Fi function to ON/OFF automatically by using the
information from the mobile network base station
Set whether to turn the Wi-Fi function to ON automatically
when the terminal detects the area where you have connected
to Wi-Fi, or turn it to OFF automatically when the terminal
detects an area where you have not connected to Wi-Fi.
1
From the Home screen,
[Wireless & networks]→[Wi-Fi]
2
[MENU]→[Advanced]→Mark/Unmark [Wi-Fi
Auto ON/OFF]
✔INFORMATION
･
The area where you have connected to an access point for 2
minutes or more consecutively with the function ON can be
detected as an area where you have connected to Wi-Fi.
･
This function does not operate when the Airplane mode or
Wi-Fi tethering is ON.
･
If Wi-Fi area information is changed etc., the terminal may not
be connected automatically with this function. In that case,
connect manually.
130
→[Settings]→
Settings