Fujitsu ARROWS NX F-01K Instruction Manual page 56

◆ Unlocking screen lock
During sleep mode, P
1
2
On the screen,
The lock is canceled.
"ひつじのしつじくん
(Butler Sheep)"
NTT DOCOMO
©
･
Depending on the setting of [Security unlock
preference] (→P150), authentication is required after
swiping on the lock screen.
･
Tap on the lock screen to activate the camera.
･
on the lock screen to activate the しゃべってコン
Tap
シェル (Shabette concier).
✔INFORMATION
･
By default, numbers of missed calls and unread docomo
mails are shown even when lock screen is displayed.
･
By default, the lock screen goes into the sleep mode after
approximately 10 seconds.
®
54
◆ Slide-in function
By default, you can call out Slide-in launcher and Capture &
Draw/Highlight & Copy by sliding your finger from the slide
spot (start point for sliding) at the corner of the screen.
･
For setting of the Slide-in function, refer to "Slide-in
function".→P164
❖
Slide-in launcher
Activate an application from a shortcut saved in Slide-in
launcher.
1
Slide your finger from the slide spot to the
center of the screen, then release the finger at
a shortcut in Slide-in launcher
･
By default, Slide-in launcher is set in the slide spot at the
lower left of the screen.
･
You can set the Slide-in function by releasing your
finger at the position of
same time as the Slide-in launcher.
2
Perform target operations
, which is called up at the
Before using the terminal