Actual Signals; Operating Data; Select - ABB ACS150 User Manual

70

Actual signals

The following table includes the descriptions of all actual signal.
Actual signals
No. Name/Value

01 OPERATING DATA

0101 SPEED & DIR
0102 SPEED
0103 OUTPUT FREQ
0104 CURRENT
0105 TORQUE
0106 POWER
0107 DC BUS VOLTAGE
0109 OUTPUT VOLTAGE
0110 DRIVE TEMP
0111 EXTERNAL REF 1
0112 EXTERNAL REF 2
0113 CTRL LOCATION
0114 RUN TIME (R)
0115 KWH COUNTER (R)
0120 AI1
0121 POT
0137 PROCESS VAR 1
0138 PROCESS VAR 2
0139 PROCESS VAR 3
0140 RUN TIME
0141 MWH COUNTER
0142 REVOLUTION CNTR
0143 DRIVE ON TIME HI
0144 DRIVE ON TIME LO
0160 DI 1-5 STATUS
0161 PULSE INPUT FREQ
0162 RO STATUS
Actual signals and parameters
Description
Basic signals for monitoring the drive (read-only).
For actual signal supervision, see parameter group
For selection of an actual signal to be displayed on the control panel, see parameter
group 34 PANEL DISPLAY.
Calculated motor speed in rpm. A negative value indicates reverse direction.
Calculated motor speed in rpm.
Calculated drive output frequency in Hz. (Shown by default on the panel Output mode
display.)
Measured motor current in A
Calculated motor torque in percent of the motor nominal torque
Measured motor power in kW
Measured intermediate circuit voltage in VDC
Calculated motor voltage in VAC
Measured IGBT temperature in °C
External reference REF1 in Hz
External reference REF2 in percent. 100% equals the maximum motor speed.
Active control location. (0) LOCAL; (1) EXT1; (2) EXT2.
Elapsed drive running time counter (hours). The counter can be reset by pressing the UP
and DOWN buttons simultaneously when the control panel is in Parameter mode.
kWh counter. The counter can be reset by pressing UP and DOWN buttons
simultaneously when the control panel is in Parameter mode.
Relative value of analog input AI1 in percent
Potentiometer value in percent
Process variable 1 defined by parameter group
Process variable 2 defined by parameter group
Process variable 3 defined by parameter group
Elapsed time counter (thousands of hours). Runs when the drive is running. Counter
cannot be reset.
MWh counter. Counter cannot be reset.
Motor revolution counter (millions of revolutions). The counter can be reset by pressing
the UP and DOWN buttons simultaneously when the control panel is in Parameter mode.
Drive control board power-on time in days. Counter cannot be reset.
Drive control board power-on time in 2 second ticks (30 ticks = 60 seconds). Counter
cannot be reset.
Status of digital inputs. Example: 10000 = DI1 is on, DI2...DI5 are off.
Value of frequency input in Hz
Status of relay output. 1 = RO is energised, 0 = RO is de-energized.
32 SUPERVISION.
34 PANEL DISPLAY
34 PANEL DISPLAY
34 PANEL DISPLAY