Panel Display; Signal3 Param - ABB ACS150 User Manual

Parameters in the Long Parameter mode
Index Name/Selection
3304 DRIVE RATING
0x0000...0xFFFF
(hex)

34 PANEL DISPLAY

3401 SIGNAL1 PARAM
0, 102...162
3402 SIGNAL1 MIN
x...x
3403 SIGNAL1 MAX
x...x
Description
Displays the drive current and voltage ratings.
Value in format XXXY:
XXX = Nominal current of the drive in Amperes. An "A" indicates decimal
point. For example if XXX is 8A8, nominal current is 8.8 A.
Y = Nominal voltage of the drive:
2 = 200...240 V
4 = 380...480 V
Selection of actual signals to be displayed on the panel
Selects the first signal to be displayed on the control panel in display mode.
3401
LOC
OUTPUT
Parameter index in group 01 OPERATING
If value is set to 0, no signal is selected.
If parameter 3401 SIGNAL1 PARAM,
SIGNAL3 PARAM values are all set to 0, n.A. is displayed.
Defines the minimum value for the signal selected by parameter
SIGNAL1 PARAM.
Display
value
3407
3406
Note: Parameter is not effective if parameter
setting is DIRECT.
Setting range depends on parameter
Defines the maximum value for the signal selected by parameter
SIGNAL1 PARAM. See the figure for parameter
Note: Parameter is not effective if parameter
setting is DIRECT.
Setting range depends on parameter
3404
3405
491
.
Hz
FWD
DATA. E.g. 102 =
3408 SIGNAL2 PARAM and
Source value
3402 3403
3404 OUTPUT1 DSP FORM
3401 setting.
3402 SIGNAL1 MIN.
3404 OUTPUT1 DSP FORM
3401 setting.
Def
0x0000
103
0101 SPEED.
3415
3401 -
-
3401 -
-
Actual signals and parameters
99