Fbxi Indicator Led Signals - ABB Cylon FBXi Series User Manual

FBXi INDICATOR LED SIGNALS

Red LED
(Power)
Green LED
(Status)
Yellow LED
(FLX)
During firmware upgrade over IP network, the Yellow LED will remain on while the strategy/comms section
reboots, and then the LEDs will rotate Red-Green-Yellow while the IO section reboots.
Note: During typical operation, the Red LED should be on, the Green
LED should be blinking and the Yellow LED should be off.
©ABB 2023 All Rights Reserved.
Subject to change without notice
WWW.CYLON.COM
USB ports
Used for firmware upgrade
Indicator LEDs
(for LED signals see
Output Override (
FBXi-8R8-H-X96
Bottom position: Off - outputs forced off.
Centre position:
Top position: Manual - for digital outputs, the output is forced on. For analog
outputs the knob setting controls the output value.
Note: Manual position is supervised, i.e. the
Push buttons
Reset to Factory default IP/Password : while the controller is
until LED lights up, then release
L2
Restart the controller: while the controller is
lights up, then release
(Reset to default Factory settings including, Shipped version of
Factory Reset
firmware, wipe strategy data, and reset IP/Password):
booting
hold until LED
SW1
LED will indicate the progress as shown in
L2
USB upgrade: insert a FAT-formatted USB drive containing valid firmware (.swu)
into either of the USB ports, while the controller is
lights up, then release
L1
LED will indicate the progress as shown in
L1
LED / LED signals
L1 L2
: Upgrade / Reset in progress
Slow blink
: Upgrade / Reset successful.
Solid colour
Power-cycle the controller to activate.
Upgrade /Reset failed
Fast blink
Inter-module connection sockets
To join the FLX bus, place the devices side-by-side and place the
into the two adjacent sockets at once.
connector
The end device on a
terminator inserted into its interconnector socket. One terminator is shipped
with each
CBXi-8R8(-H)
Off
Power is off Power is on
Strategy Loaded
Unit is not
but no network
running
connectivity
FLX bus comms
No FLX bus comms
are ok
FBXi Series |
FBXi Indicator LED Signals
only)
Auto - outputs are controlled by strategy.
strategy
.
SW1
running
.
SW2
lights up, then release
L2
L1
.
SW1
L1
FLX bus (either a device or the
FLX
device.
On Slow Blink
___ Unit Rebooting ___
Strategy Loaded and
device communicating
on network
FLX bus address clash
FBXi Operation
on page 73)
is aware of the manual value.
running
, press
, press until LED
SW2
while the controller is
.
SW1
/ signals below.
L2
booting
hold until LED
SW1
/ signals below.
L2
FLX bus
itself) must have a
CBXi
Fast blink
No Strategy
loaded
FLX bus
comms error
SW1
L2
73