Motor Potentiometer Macro; Default I/O Connections - ABB ACS150 User Manual

62

Motor Potentiometer macro

This macro provides a cost-effective interface for PLCs that vary the speed of the
drive using only digital signals. To enable the macro, set the value of parameter
to 4 (MOTOR POT).
For the parameter default values, see section
macros
see section

Default I/O connections

1)
If DI3 and DI4 are both active or inactive, the
frequency reference is unchanged.
The existing frequency reference is stored
during stop and power down.
Application macros
on page 65. If you use other than the default connections presented below,
I/O terminals on page 34.
I/O connection
SCR
AI
GND
+10V
+24V
GND
DCOM
DI1
DI2
DI3
DI4
DI5
Relay connection
COM
NC
NO
Default parameter values with different
2)
Signal cable shield (screen)
Not in use by default: 0...20 mA
Analog input circuit common
Reference voltage: +10 VDC, max. 10 mA
Auxiliary voltage output: +24 VDC, max. 200 mA
Auxiliary voltage output common
Digital input common
Stop (0) / Start (1)
Forward (0) / Reverse (1)
Frequency reference up
Frequency reference down
Constant speed 1: parameter
3)
Relay output
No fault [Fault (-1)]
2)
Tightening torque = 0.22 N·m / 2 lbf. in
3)
Tightening torque = 0.5 N·m / 4.4 lbf. in.
1)
1)
1202
9902