[Basic] > [Video]; Setting Video Size And Quality; Jpeg - Canon ME20F-SHN Network Operation Manual

[Basic] > [Video]

Setting Video Size and Quality

General video settings, such as the size and quality of JPEG and H.264 video transmitted from the camera.
[Video] is common with [Video] found in [Video and Audio] and [Video Record]. A setting configured in any of the [Video]
submenus will be reflected in the other [Video] submenus as well.
Important
• The following may occur if video size, video quality and target bit rate are set higher, as this increases network load and data size per
frame.
– JPEG: The frame rate may drop
– H.264: Video may be temporarily disrupted
• In case of H.264 video, block noise may become noticeable if a large video size and low target bit rate are set.
• The data size may increase depending on the type or movement of the subject. If the frame rate remains low or other undesirable
conditions continue for a prolonged period, lower the video size or quality setting.

JPEG

You can configure settings for the quality and size of JPEG video transmitted from the camera, as well as, the video size
when recording the camera video.
[Video Quality]
Select the video quality transmitted from the camera for each video size.
Greater values have higher quality.
[Video Quality: Digital PTZ]
Select the video quality for digital PTZ.
[Video Size: video Transmission]
Select the default video size transmitted from the camera when no video size has been specified by the Viewer.
[Maximum Frame Rate: Video Transmission]
Limit the maximum frame rate per second transmitted to reduce the viewer load. Up to 30 frames per second can be set.
[Video Size: Memory card]
Select the size of video when recording to a memory card (P. 146).
The following settings can be configured here.
• JPEG
• H.264(1)
• H.264(2)
4
75