Table of Contents
Advertisement
[IKE Pre-Shared Key]
Enter the pre-shared key for IKE (auto key exchange).
Manual
[IPsec Set]
Select which IPsec sets the camera will use; IPv4, IPv6, or neither.
[IPsec Mode]
Select the IPsec mode.
[Destination IPv4 Address], [Destination IPv6 Address]
Enter the IP address of the connection destination.
[Source IPv4 Address], [Source IPv6 Address]
Enter the IP address of the source.
[IPsec Protocol]
Select the IPsec protocol.
If you select [ESP], enter only the setting items relating to ESP.
If you select [AH], enter only the setting items relating to AH.
If you select [ESP and AH], enter all setting items.
[Security Gateway IPv4 Address], [Security Gateway IPv6 Address]
Enter the IP address of the security gateway if [IPsec Mode] is set to [Tunnel Mode].
[Destination Subnet Mask Length], [Destination Prefix Length]
Enter the subnet mask (IPv4) or prefix length (IPv6) when [IPsec Mode] is set to [Tunnel Mode].
If the Setting in [IPsec Protocol] Includes "ESP"
[SA ESP Encryption Algorithm]
Set the ESP encryption algorithm to suit the encryption algorithm supported by the device to connect to.
Normally [AES] or [3DES] is recommended.
[SA ESP Authentication Algorithm]
Set the ESP authentication algorithm to suit the authentication algorithm supported by the device to connect to.
If [ESP] is used alone, [No Authentication] cannot be selected.
[SA ESP Encryption Key (outbound)]
Enter the SA encryption key for outbound.
If [AES], [3DES] or [DES] was selected in [SA ESP Encryption Algorithm], set a 128-bit, 192-bit or 64-bit hexadecimal
number, respectively. This item need not be set if [NULL] was selected.
[SA ESP Authentication Key (outbound)]
Enter the SA authentication key for outbound.
If [HMAC_SHA1_96] or [HMAC_MD5_96] was selected in [SA ESP Authentication Algorithm], set a 160-bit or 128-bit
hexadecimal number, respectively. This item need not be set if [No Authentication] was selected.
[SA ESP SPI (outbound)]
Enter the SA SPI value for outbound.
Set a desired value in the range of 256 to 4294967295.
[SA ESP Encryption Key (inbound)]
Enter the SA encryption key for inbound.
If [AES], [3DES] or [DES] was selected in [SA ESP Encryption Algorithm], set a 128-bit, 192-bit or 64-bit hexadecimal
number, respectively. This item need not be set if [NULL] was selected.
[SA ESP Authentication Key (inbound)]
Enter the SA authentication key for inbound.
If [HMAC_SHA1_96] or [HMAC_MD5_96] was selected in [SA ESP Authentication Algorithm], set a 160-bit or 128-bit
hexadecimal number, respectively. This item need not be set if [No Authentication] was selected.
[SA ESP SPI (inbound)]
Enter the SA SPI value for inbound.
Set a desired value in the range of 256 to 4294967295.
144
Advertisement
Table of Contents
Troubleshooting
