Canon ME20F-SHN Network Operation Manual page 159

S311 Working error in external input/output
service [err]
Description cannot work extio [%1][%2][%3]
(S311)
%1 Error number
%2 Cause of error
%3 Error information
Meaning An error occurred while the external
input/output device service was
running.
Countermeasure If the problem persists after rebooting,
the camera is faulty. Arrange for
servicing.
S312 Working error in timer service [err]
Description cannot work timer [%1][%2][%3]
(S312)
%1 Error number
%2 Cause of error
%3 Error information
Meaning An internal error occurred in the timer
service.
Countermeasure If the problem persists after rebooting,
the camera is faulty. Arrange for
servicing.
S320 PAN/TILT operation error [err]
Description %1 error occurred. [%2] (S320)
%1 PAN | TILT
%2 Warning details
Meaning An error occurred during operation or
stopping of PAN/TILT.
Countermeasure Check that the camera is not touching
the dome, etc.
If the error is not caused by problems
such as contact with peripheral items,
the camera is faulty. Arrange for
servicing.
S330 Failure of the fan [err]
Description fan [%1] is stopped. (S330)
%1 Fan number
Meaning The fan does not rotate or is detected
that the rotation speed has been
considerably lowered.
Countermeasure If the problem persists after rebooting,
the fan may be faulty. Arrange for
servicing.
S340 Temperature warning [err]
Description The camera's internal temperature has
risen to a predetermined level. (S340)
Meaning The camera's internal temperature is
unnecessarily high.
Countermeasure Turn off the camera and wait until the
temperature has decreased. If the
problem persists, arrange for
servicing.
S341 Cooling fan warning [err]
Description The cooling fan may not be working
properly. (S341)
Meaning The cooling fan may be faulty.
Countermeasure Arrange for servicing.
S342 Lens communication error [err]
Description There was a communication error
between the camera and the lens.
(S342)
Meaning Unable to communicate with the lens
normally.
Countermeasure Reboot the camera. Alternatively, turn
off the camera, remove the lens, and
clean the lens's contact. If the problem
persists, arrange for servicing.
S343 ABB error [err]
Description An error occurred while the camera
was automatically adjusting the black
balance. (S343)
Meaning The automatic black balance (ABB)
may not have functioned correctly.
Countermeasure Firmly attach the body cap to block
light from entering the camera, and
then perform the ABB operation again
(refer to "Setup Guide" for details of
operating procedure). If the problem
persists, arrange for servicing.
S410 Event service initialization error [crit]
Description event initialization error [%1][%2]
(S410)
%1 Error number
%2 Cause of error
Meaning An error occurred in the initialization of
the event service.
Countermeasure If the problem persists after rebooting,
the camera is faulty. Arrange for
servicing.
5
159