Table of Contents
Advertisement
21128026 R001 DSAM Help User Guide.book Page 275 Thursday, February 5, 2009 2:02 PM
Understanding
Forward Sweep
Results
DSAM Help User Guide
Figure 249 Measure Mode – Forward Sweep
5 Press the Settings softkey.
6 Using the arrow keys, select one of the following options:
– Test Point Comp – Displays the Test Point Compensation
screen
("Test Point Compensation" on page
– Telemetry Frequency... – Displays the Telemetry Settings
screen
("Configuring Telemetry Frequency" on page
– Sweep Tilt and Limit... – Displays the Sweep Settings
screen
("Sweep Settings" on page
7 Using the arrow keys and the alphanumeric keypad, highlight and
edit the parameters as needed.
8 Press the OK softkey.
NOTE
All settings made in the Telemetry Settings screen are saved in the
active channel plan identified in the upper right-hand corner of the
screen. Be sure to select the appropriate channel plan for the net-
work you are working with.
The Forward Sweep measurement mode provides signal levels of all
frequency points which are then displayed on a graph.
Rev. 001
Chapter 11 Measure Mode – Sweep Tab
Forward Sweep
71).
86).
55).
275
Advertisement
Table of Contents
