Saving Results Successively - JDS Uniphase ORL-55 Series Operating Manual

6 M
EMORY

Saving results successively

Results are stored simply by pressing the STORE key.
Each time the key is pressed, the next memory location
will be used to store the current result. If the memory is
initially empty, the memory starts with Group 001 and
Meas 001. The Meas # then increments each time the
STORE key is pressed (up to a maximum of 350).
This method is ideal for simple measurement
sequences, e.g. when a limited number of power level
values for a single item under test are to be recorded.
To save current results successively:
 The entire result memory is empty or the first and sub-
sequent memory locations are empty.
 The device is in measure mode.
1. Press the [Store] key to save the first result.
The display briefly indicates the first memory location,
e.g. Group 033, Meas 001. "Storing ..." confirms the
storing process is successful.
2. Press the [Store] key again every time you want to
save a further result value.
The display briefly shows the memory location used.
The Meas # increments each time.
If the results are to be stored starting from a different
memory location, such as Group 015, Meas 005, these
values must be specified in advance (see
store location" on page
If you attempt to store data at memory locations that are
already occupied by the results of previous
measurements, a warning will be displayed:
40
M
ANAGEMENT
43).
ORL-55
„Selecting the
JDSU