21128026 R001 DSAM Help User Guide.book Page 8 Thursday, February 5, 2009 2:02 PM
Chapter 2 DSAM Navigation
The Keypad
The Keypad
Softkeys
Exit Key
Enter Key
Arrow Keys
Mode Keys
Alphanumeric
Keypad
Shift Key
8
To open the menu item (on the screen), press any of the four softkeys
located under the screen.
NOTE
Press the blue "Shift" key to change these menu items to mea-
surement mode softkeys, then press the corresponding softkey to
go directly to that measurement mode. For more information, see
"Shift Key" on page
8.
To leave the screen or function you are currently viewing, press the
crescent-shaped EXIT key (located to the left of the arrow keys).
To affirm or input data and to execute tasks in each mode, press the
crescent-shaped ENTER key (located to the right of the arrow keys).
Using the arrow keys, select softkey pop-up menu options, select
mode options, move the cursor, and adjust the view (on some
screens).
To directly access functions within one of the following modes, press
one of the round mode keys.
– AutoTest
– Measure
– Access
– Configure
Use the alphanumeric keys to enter numeric values, letters, and
spaces. Where applicable, repeat presses of the same key cycle
through the characters (such as 2, then a, then b, then c, then 2, etc.).
Press the blue shift key before pressing an alphanumeric key to
access the shortcut option associated with the alphanumeric key.
Icons associated with each shortcut are located below the alphanu-
meric key.
DSAM Help User Guide
Rev. 001