Table of Contents
Advertisement
21128026 R001 DSAM Help User Guide.book Page 158 Thursday, February 5, 2009 2:02 PM
Chapter 8 Measure Mode – Basic Tab
MiniScan
MiniScan
Running a
MiniScan
158
A MiniScan analyzes and displays the carrier levels of up to twelve
channels and displays the results on a single screen. You can view the
results in graph or table form and measure them in relation to pre-
configured limit sets. You can save test results for later reference.
NOTE
MiniScan measurement channels are user-defined and correspond
to a single Channel Plan. You can select up to twelve channels
within each Channel Plan. See
on page 84
for more information.
If no channels are enabled for MiniScan, an error message is dis-
played.
To run a MiniScan
1 Press Measure.
2 Press the Basic softkey.
Figure 145 Measure Mode – Basic Tab
3 Using the arrow keys, select MiniScan.
4 Press ENTER.
"Configuring Channels for MiniScan"
DSAM Help User Guide
Rev. 001
Advertisement
Table of Contents
