Table of Contents
Advertisement
21128026 R001 DSAM Help User Guide.book Page 123 Thursday, February 5, 2009 2:02 PM
DSAM Help User Guide
Figure 115 AutoTest – Video AutoTest
5 Using the arrow keys, select Channel Plan.
6 Press ENTER.
7 Using the arrow keys, select an option.
8 Press ENTER.
9 Using the arrow keys, select Limit Plan.
10 Press ENTER.
NOTE
To perform the test without checking the results against limit values,
select Off.
If you select Off as the Limit Plan value, no pass/fail information is
displayed in the test results.
11 Using the arrow keys, select an option.
12 Press ENTER.
NOTE
Use
"Regional Preferences" on page 43
level units and digital performance units to display.
Use
"Limit Sets" on page 58
your needs.
Use
"Other Settings" on page 65
settings (such as DOCSIS settings) for your current work practices.
Rev. 001
Chapter 7 AutoTest Mode
to specify the type of signal
to edit limit set parameters to meet
to define the best measurement
AutoTests Tab
123
Advertisement
Table of Contents
