21128026 R001 DSAM Help User Guide.book Page 230 Thursday, February 5, 2009 2:02 PM
Chapter 9 Measure Mode – Service Tab
Ethernet
Restoring Ping Test
Defaults
230
15 Press ENTER.
16 Press the Start softkey.
When a ping test starts, response results begin scrolling upward in
the response box (upper right corner of the screen). The most
recent ping result is displayed at the bottom of the list.
The status box (in the lower right corner of the screen) displays
the reply statistics, including:
– Number of pings sent
– Average return time
– Number of pings lost
– Ratio of lost to sent pings
Ping data is continuously updated.
Figure 206 Measure Mode – Ethernet Ping Test
Table 46 Ping Test Parameters
Name
Description
IP Address
Select from a list of up to ten of the most recently
used IP addresses.
Packet Size
Options are 64, 128, 256, 512, 1024, or 1518 (in
(bytes)
bytes). The default value is 64 bytes.
Time Between
Options are 0 ms, 10 ms, 25 ms, 50 ms, 100 ms, 1
Pings
sec, 2 sec, or 5 sec. The default value is 1 second.
To restore the default values for Packet Size and Time Between Pings.
DSAM Help User Guide
Rev. 001